Schilling SP100+ Manual de Instruções descarregar pdf (Página 43)

4.2 Gap/Black Mark Calibration, Self-test and Dump

Mode

While calibrate the gap/black mark sensor, printer will measure the label length,

print the internal configuration (self-test) on label and then enter the dump

mode. To calibrate gap or black mark sensor, depends on the sensor setting in

the last print job.

Please follow the steps below to calibrate the sensor.

1.Turn off the power switch.

2. Hold on the button then turn on the power switch.

3. Release the button when LED becomes amber and blinking. (Any amber

will do during the 5 blinks).

 The LED color will be changed as following order.

Amber  red (5 blinks)  amber (5 blinks)  green (5 blinks) 

green/amber (5 blinks)  red/amber (5 blinks)  solid green

4. It calibrates the sensor and measures the label length and prints internal

settings then enter the dump mode.

Note:

Please select gap or black mark sensor by GAP or BLINE command prior

to calibrate the sensor.

For more information about GAP and BLINE command, please refer to

TSPL2 programming manual.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 55 56

Sem comentários

Schilling SP100+ Manual de Instruções Página 43